Clutch Puller for Ski-Doo Alpine 500/503 1983-1987
Clutch Puller for Ski-Doo Alpine 500/503 1983-1987
Couldn't load pickup availability
Clutch Puller for Ski-Doo Alpine 500/503
This clutch puller is a removal tool made for the 1983-1987 Ski-Doo Alpine 500 and 503, allowing you to pull the drive clutch off the crankshaft without damage.
Overview
This clutch puller is a dedicated removal tool for the 1983-1987 Ski-Doo Alpine 500 and 503. It threads into the clutch and bears against the crank end so the clutch releases evenly instead of being pried or struck. A clutch puller is a must-have for Alpine owners handling clutch maintenance and driveline repairs.
Built For Performance
- Threaded nose seats into the clutch center for an even pull
- Solid steel shaft keeps the tool rigid under load
- Sized for the Alpine 500 and 503 clutch assembly
- Accepts a standard wrench or socket for steady torque
- Reusable design for repeated service
Fits These Machines
- for Ski-Doo Alpine 500, 1983-1987
- for Ski-Doo Alpine 503, 1983-1987
On-The-Job Use
- Pulling the drive clutch for inspection or replacement
- Clutch and belt service on 1980s Alpine sleds
- Crankshaft seal or bearing access during rebuilds
- Shop or trailside repairs that require the clutch off the crank
Specs At A Glance
| Tool Type | Clutch puller |
| Application | Drive clutch removal |
| Models | Alpine 500, 503 |
| Model Years | 1983-1987 |
Good To Know
Q: How does this puller remove the clutch? A: After the retaining bolt is out, the puller threads into the clutch and presses on the crank end to push the clutch free.
Q: Does it fit both Alpine engine sizes? A: It is intended for the Alpine 500 and 503, so verify your clutch thread size before ordering.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
