Clutch Puller for Ski-Doo Formula 500 Deluxe 1997-2000
Clutch Puller for Ski-Doo Formula 500 Deluxe 1997-2000
Couldn't load pickup availability
Clutch Puller for Ski-Doo Formula 500 Deluxe
This clutch puller removes the drive clutch from 1997 to 2000 Ski-Doo Formula 500 Deluxe snowmobiles, threading into the clutch center to press it free from the crankshaft taper.
Overview
This clutch puller is made for the Ski-Doo Formula 500 Deluxe and gives you the correct threaded tool for safe drive clutch removal at home or in the shop. It threads into the clutch and uses the center bolt to push the clutch off the crankshaft taper without damaging the sheaves or crank. A must-have for anyone servicing the clutch on a Ski-Doo Formula 500 Deluxe.
Built For Performance
- Hardened steel body resists deformation under high torque loads
- Precision-cut threads match the clutch center for a secure, wobble-free fit
- Center bolt engages the crankshaft end to press the clutch free evenly
- Durable finish protects against corrosion in cold, wet snowmobile conditions
- Compact length fits inside tight engine bay clearance on the Formula chassis
Fits These Machines
- for Ski-Doo Formula 500 Deluxe 1997
- for Ski-Doo Formula 500 Deluxe 1998
- for Ski-Doo Formula 500 Deluxe 1999
- for Ski-Doo Formula 500 Deluxe 2000
On-The-Job Use
- Clutch servicing and spring or weight changes in the shop
- Trailside or garage removal during belt and clutch maintenance
- Crankshaft seal replacement jobs that require clutch removal
- Pre-season teardown and inspection on the Formula chassis
Specs At A Glance
| Part Type | Clutch Puller |
| Brand Fitment | for Ski-Doo |
| Model | Formula 500 Deluxe |
| Years Covered | 1997, 1998, 1999, 2000 |
Good To Know
Q: Do I need to remove the clutch bolt before using this puller? A: Yes, remove the outer clutch bolt first, then thread the puller into the clutch center and tighten the center bolt to press the clutch off. Always thread it in by hand at least a few turns before applying torque.
Q: Will this puller damage the crankshaft threads? A: When threaded in fully and aligned straight, the center bolt pushes against the crank end rather than the threads. Keeping the puller square and snug helps prevent thread damage.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
