Clutch Puller for Ski-Doo Summit 500 1999
Clutch Puller for Ski-Doo Summit 500 1999
Couldn't load pickup availability
Clutch Puller for Ski-Doo
This clutch puller is a dedicated removal tool for Ski-Doo snowmobile drive clutches, allowing you to press the clutch off the crankshaft taper safely and evenly.
Overview
This clutch puller for Ski-Doo is made for pulling the drive clutch when service or a rebuild is due. It threads into the clutch and pushes against the crank end, breaking the taper fit so the clutch slides free. A practical tool for riders and mechanics maintaining older Ski-Doo sleds.
Built For Performance
- Hardened steel construction stands up to repeated pulling force
- Cleanly cut threads seat firmly in the clutch hub
- Machined center tip applies even pressure on the crankshaft
- Short body fits within tight engine compartments
- Works with common hand tools for controlled torque
Fits These Machines
- for Ski-Doo Summit 500 (1999)
On-The-Job Use
- Clutch removal for spring, weight, or roller replacement
- Crankshaft seal and bearing service
- Belt drive inspection that requires clutch access
- Seasonal maintenance on older Summit sleds
Specs At A Glance
| Type | Clutch puller tool |
| Fitment | for Ski-Doo Summit 500, 1999 |
| Material | Hardened steel |
Good To Know
Q: Will this puller fit later Summit models? A: It is listed for the Summit 500 (1999); clutch thread sizes changed across model years, so verify your clutch before ordering. Q: How do I keep the clutch from spinning while pulling? A: Hold the clutch with a strap or clutch holder tool so the puller threads bite instead of turning the assembly.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
