Complete Bearing Housing for Yamaha 212 S 1800 2020-2022

Complete Bearing Housing for Yamaha

This complete bearing housing is a ready-to-install assembly for Yamaha 212 S 1800 jet boats, combining the housing with its bearing and seals to keep the drive shaft supported and the pump aligned.

Overview

This complete bearing housing is built for Yamaha 212 S 1800 owners replacing a worn intermediate bearing assembly in a single job. The bearing housing holds the shaft steady between the coupler and jet pump, cutting vibration and protecting the driveline. It fits routine service, rebuild work, and repairs after seal failure.

Built For Performance

• Complete unit with housing, bearing, and seals fitted
• Machined housing bore for accurate bearing seating
• Sealed bearing construction limits water and grit entry
• Direct fitment for Yamaha 1800 series jet drive applications
• Assembly-ready so no separate pressing of loose parts is required

Fits These Machines

• for Yamaha 212 S 1800, 2020-2022

On-The-Job Use

• Scheduled jet pump and driveline maintenance
• Repair after water intrusion or bearing noise
• Pre-season and winterization service
• Rebuilds on higher-hour 212 S boats

Specs At A Glance

Good To Know

Q: Is the bearing already installed in the housing? A: Yes, this arrives as a complete bearing housing with the bearing and seals in place. You remove the old assembly and install the new one as a unit.

Q: What tells me the bearing housing is failing? A: Rumbling or grinding near the pump, shaft movement, or water weeping past the seals are the common indicators. Check the part number on your current housing to confirm the match.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.