Complete Bearing Housing for Yamaha 212 SS 1800 2012-2016

Complete Bearing Housing for Yamaha

This complete bearing housing is a drop-in assembly for Yamaha 212 SS 1800 jet boat drives, carrying the shaft bearing, seals, and housing in one unit so the pump turns true and stays aligned.

Overview

This complete bearing housing serves Yamaha 212 SS 1800 owners who need to replace a worn or noisy intermediate bearing assembly in one step rather than pressing individual parts. The bearing housing supports the drive shaft between the engine coupler and jet pump, keeping alignment steady under load. It suits routine rebuilds, seasonal service, and repairs after water intrusion.

Built For Performance

• Complete assembly with housing, bearing, and seals installed
• Precision-machined housing bore for correct bearing seating
• Sealed bearing design resists water and debris intrusion
• Direct fitment for Yamaha 1800 series jet drive applications
• Rebuild-ready so the shaft assembly can be swapped without pressing loose components

Fits These Machines

• for Yamaha 212 SS 1800, 2012-2016

On-The-Job Use

• Scheduled jet pump and driveline service
• Repair after water intrusion or bearing noise
• Winterization and pre-season maintenance
• Rebuilds on higher-hour 212 SS boats

Specs At A Glance

Good To Know

Q: Do I need to press the bearing in myself? A: No, this ships as a complete bearing housing with the bearing and seals already seated in the housing. Installation is a matter of removing the old assembly and fitting the new one.

Q: How do I know if my bearing housing needs replacement? A: Grinding or rumbling from the pump area, shaft play, or water weeping past the seals are the usual signs. Confirm the part number stamped on your existing housing before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.