Complete Bearing Housing for Yamaha 212 X 1800 2012-2020

Complete Bearing Housing for Yamaha 212 X 1800

This complete bearing housing assembly is a direct-fit replacement for the Yamaha 212 X 1800 jet pump, supporting the driveshaft bearings and seals that keep the pump turning smoothly.

Overview

This complete bearing housing for Yamaha 212 X 1800 watercraft delivers the housing, bearing, and seal components as one ready-to-fit unit. It holds the jet pump driveshaft in alignment and protects the bearing surfaces from water intrusion. A practical choice for owners and shops servicing 2012 to 2020 models.

Built For Performance

• Complete assembly with housing, bearing, and seal components pre-fitted
• Machined bore for accurate bearing seating and shaft alignment
• Sealed bearing arrangement resists water intrusion in jet pump service
• Direct replacement footprint for the Yamaha 212 X 1800 pump assembly
• Corrosion-resistant housing finish for regular marine exposure
• Fits with standard jet pump service tools

Fits These Machines

• for Yamaha 212 X 1800, 2012-2020

On-The-Job Use

• Jet pump rebuilds and driveshaft bearing service
• Routine maintenance on 212 X 1800 boats
• Replacing a noisy or water-damaged bearing housing
• Repair work following impeller or wear ring service

Specs At A Glance

Good To Know

Q: Is this a complete bearing housing? A: Yes, it arrives as a complete bearing housing assembly with the bearing and seal components already fitted for installation. Q: Does it cover the full 2012 to 2020 range? A: It is listed for the 212 X 1800 across those years, but serial number differences can affect fit, so verify compatibility before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.