Complete Bearing Housing for Yamaha AR 240 HO 1800 2010-2020

Complete Bearing Housing for Yamaha

This complete bearing housing is a drop-in replacement assembly for the Yamaha AR 240 HO 1800 jet boat, carrying the bearings and seals that support the driveshaft so it rotates smoothly and stays sealed against water.

Overview

This complete bearing housing for Yamaha is a ready-to-install assembly that supports the driveshaft and protects the driveline from water intrusion. It is made for boat owners who need to replace a worn or noisy bearing housing on a Yamaha AR 240 HO 1800 without tracking down individual bearings and seals. As a complete bearing housing, it streamlines the repair and helps keep your jet boat running reliably.

Built For Performance

• Complete assembly with bearings and seals already fitted
• Housing machined to keep the driveshaft properly centered
• Seals block water from entering at the hull pass-through
• Direct-fit replacement in the stock housing location
• Corrosion-resistant construction for marine environments
• Helps cut vibration caused by worn bearing surfaces

Fits These Machines

• for Yamaha AR 240 HO 1800, 2010-2020

On-The-Job Use

• Replacing a rough or noisy bearing housing
• Driveline service after a seal leak or water intrusion
• Routine jet pump and driveshaft maintenance
• Restoring smooth shaft rotation on an AR 240 HO 1800

Specs At A Glance

Good To Know

Q: Is this an original Yamaha part? A: No, this is an aftermarket complete bearing housing designed to fit the Yamaha AR 240 HO 1800. It is not manufactured by Yamaha.

Q: Does it come with bearings and seals? A: Yes, it is supplied as a complete assembly with bearings and seals. Check your driveshaft and mounting hardware during installation, and confirm your serial number before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.