Complete Bearing Housing for Yamaha FX SHO 1800 2008-2015

Complete Bearing Housing for Yamaha FX SHO 1800

This Complete Bearing Housing is a replacement driveline component that supports the jet pump shaft and keeps it turning smoothly on Yamaha FX SHO 1800 watercraft built from 2008 through 2015.

Overview

The Complete Bearing Housing for Yamaha FX SHO 1800 is a ready-to-install assembly that holds the pump shaft bearing and seals the driveline against water entry. It replaces a worn or corroded housing and restores steady shaft rotation on 2008-2015 FX SHO 1800 models. This bearing housing for Yamaha fits riders handling their own pump and driveline service.

Built For Performance

• Complete assembly with housing and bearing fitted for direct replacement
• Matched to the FX SHO 1800 driveline shaft layout
• Sealed design helps keep water and debris away from the bearing
• Machined housing face for a clean seat against the pump section
• Built to take the thrust loads of jet pump operation

Fits These Machines

• for Yamaha FX SHO 1800, 2008-2015

On-The-Job Use

• Pump and driveline service on FX SHO 1800 watercraft
• Replacing a noisy or seized shaft bearing
• Rebuilding the jet pump section after water intrusion
• Routine driveline inspection and refresh

Specs At A Glance

Good To Know

Q: Is the bearing included with this housing? A: Yes, it arrives as a complete bearing housing assembly with the bearing already in place.

Q: Should I replace the seals at the same time? A: Fresh seals are recommended, since they help keep water out of the bearing and extend its service life.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.