Complete Bearing Housing for Yamaha FX SVHO 1800 2014-2026

Complete Bearing Housing for Yamaha FX SVHO 1800

This Complete Bearing Housing is a replacement driveline component that supports the jet pump shaft and keeps it spinning true on Yamaha FX SVHO 1800 watercraft from 2014 through 2026.

Overview

The Complete Bearing Housing for Yamaha FX SVHO 1800 is a ready-to-install assembly that carries the pump shaft bearing and seals the driveline against water intrusion. It restores smooth shaft rotation and replaces a worn or corroded housing on 2014-2026 FX SVHO 1800 models. This bearing housing for Yamaha suits riders doing their own pump and driveline maintenance.

Built For Performance

• Complete assembly with housing and bearing installed for direct replacement
• Designed for the FX SVHO 1800 driveline shaft layout
• Sealed construction helps block water and debris from the bearing
• Machined housing face for a clean fit against the pump section
• Built to handle the thrust loads of high-output jet pump operation

Fits These Machines

• for Yamaha FX SVHO 1800, 2014-2026

On-The-Job Use

• Pump and driveline service on FX SVHO 1800 watercraft
• Replacing a noisy or seized shaft bearing
• Rebuilding the jet pump section after water intrusion
• Routine driveline inspection and refresh

Specs At A Glance

Good To Know

Q: Does this housing come with the bearing already installed? A: Yes, it is supplied as a complete bearing housing assembly so the bearing does not need to be pressed in separately.

Q: Can I reuse my old seals with this housing? A: Reusing worn seals is not advised, since fresh seals help keep water out of the bearing and extend service life.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.