Complete Bearing Housing for Yamaha FZR 1800 2009-2016

Complete Bearing Housing for Yamaha FZR 1800

This complete bearing housing is a direct-fit replacement assembly for Yamaha FZR 1800 watercraft, built to support the driveshaft bearing at the pump end of the driveline.

Overview

This complete bearing housing for Yamaha FZR 1800 provides a ready-to-install assembly that carries the driveshaft bearing and holds the shaft in proper alignment. It suits riders replacing a worn, corroded, or noisy housing without sourcing separate seals and hardware. Fitting 2009 through 2016 models, the bearing housing for Yamaha FZR 1800 restores reliable bearing support inside the jet pump assembly.

Built For Performance

• Complete assembly ships with the bearing already installed
• Precision-machined bore keeps the bearing square to the driveshaft
• Corrosion-resistant finish handles repeated water exposure
• Sealed bearing keeps water and debris out of the rolling elements
• Mounting pattern matches the original housing for bolt-on fitment

Fits These Machines

• for Yamaha FZR 1800 (2009-2016)

On-The-Job Use

• Driveline rebuilds after bearing noise or vibration appears
• Jet pump service where the housing shows corrosion or a worn bearing seat
• Shaft alignment checks during pump removal and reinstallation
• Scheduled maintenance on high-hour FZR 1800 watercraft

Specs At A Glance

Good To Know

Q: Is the bearing already pressed into the housing? A: Yes, this complete assembly arrives with the bearing fitted, so it installs as a single unit.

Q: What else should I check during installation? A: Inspect the driveshaft, seals, and coupler for wear, since a worn shaft can reduce the service life of a new bearing housing.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.