Complete Bearing Housing for Yamaha GP HO 1900 2024-2026

Complete Bearing Housing for Yamaha

This complete bearing housing is a replacement driveline component for Yamaha GP HO 1900 personal watercraft, and it carries the bearing assembly that supports the driveshaft between the engine and the jet pump.

Overview

This complete bearing housing for Yamaha is a drop-in replacement assembly for the 1900cc GP HO platform. It holds and aligns the driveshaft bearing so the shaft spins true under load, reducing vibration and wear across the driveline. It suits riders and shops servicing a 2024-2026 GP HO 1900 that needs a fresh bearing housing.

Built For Performance

• Complete assembly with housing and bearing pre-installed
• Machined housing bore for correct bearing alignment
• Sealed bearing design keeps water and debris out
• Built to handle continuous high-RPM driveshaft loads
• Direct replacement footprint for the GP HO 1900 driveline
• Corrosion-resistant housing finish for marine use

Fits These Machines

• for Yamaha GP HO 1900, 2024-2026

On-The-Job Use

• Driveline rebuilds on 2024-2026 GP HO 1900 watercraft
• Replacing a worn or noisy driveshaft bearing housing
• Routine pump and shaft service intervals
• Shop repairs after water intrusion or bearing failure

Specs At A Glance

Good To Know

Q: Does this come with the bearing already installed? A: Yes, this is a complete bearing housing assembly, so the bearing is fitted in the housing and ready to install on the driveshaft. Q: Will this fit every GP HO 1900 built from 2024 to 2026? A: It is listed for the 2024-2026 GP HO 1900, but Yamaha can change driveline parts mid-production, so verify your model and serial number before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.