Complete Bearing Housing for Yamaha GP-R 1800 2019

Complete Bearing Housing for Yamaha GP-R 1800

This complete bearing housing is a drop-in replacement assembly for the Yamaha GP-R 1800, built to support the driveshaft and keep the jet pump turning smoothly.

Overview

This complete bearing housing for Yamaha GP-R 1800 models provides a ready-to-install assembly for the jet pump driveline. The bearing housing for Yamaha GP-R 1800 holds the shaft bearing and seals in place, helping maintain alignment under load for steady pump operation. It is intended for riders servicing the jet pump on 2019 machines.

Built For Performance

• Complete assembly with housing, bearing, and seals ready to install
• Machined housing bore for consistent bearing fit and shaft alignment
• Sealed design to keep water and debris away from the bearing
• Built to handle the thrust loads of a jet pump driveline
• Direct replacement for the stock part on GP-R 1800 models

Fits These Machines

• for Yamaha GP-R 1800, 2019

On-The-Job Use

• Replacing a noisy or rough jet pump bearing
• Servicing the driveline during pump rebuilds
• Restoring smooth shaft rotation after water intrusion
• Routine maintenance on 2019 GP-R 1800 machines

Specs At A Glance

Good To Know

Q: Does this come as a complete assembly? A: Yes, the bearing housing ships as a complete unit with the bearing and seals already installed. Q: Will it fit my specific model year? A: It is listed for 2019 GP-R 1800 models, but you should confirm fitment against your serial number before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.