Complete Bearing Housing for Yamaha GP-R HO 1800 2020-2023

Complete Bearing Housing for Yamaha GP-R HO 1800

This complete bearing housing is a drop-in replacement assembly for the Yamaha GP-R HO 1800, designed to support the driveshaft and keep the jet pump spinning true.

Overview

This complete bearing housing for Yamaha GP-R HO 1800 models gives you a ready-to-install assembly for the jet pump driveline. The bearing housing for Yamaha GP-R HO 1800 carries the shaft bearing and seals, helping hold alignment under load so the pump runs smoothly. It suits riders replacing worn or noisy jet pump bearings on 2020 through 2023 machines.

Built For Performance

• Complete assembly with housing, bearing, and seals ready to install
• Machined housing bore for consistent bearing fit and shaft alignment
• Sealed design to keep water and debris away from the bearing
• Built to handle the thrust loads of a jet pump driveline
• Direct replacement for the stock part on GP-R HO 1800 models

Fits These Machines

• for Yamaha GP-R HO 1800, 2020
• for Yamaha GP-R HO 1800, 2021
• for Yamaha GP-R HO 1800, 2022
• for Yamaha GP-R HO 1800, 2023

On-The-Job Use

• Replacing a noisy or rough jet pump bearing
• Servicing the driveline during pump rebuilds
• Restoring smooth shaft rotation after water intrusion
• Routine maintenance on 2020 to 2023 GP-R HO 1800 machines

Specs At A Glance

Good To Know

Q: Does this come as a complete assembly? A: Yes, the bearing housing ships as a complete unit with the bearing and seals already installed. Q: Will it fit my specific model year? A: It is listed for 2020 through 2023 GP-R HO 1800 models, but you should confirm fitment against your serial number before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.