Complete Bearing Housing for Yamaha SX 195 1800 2017-2026

Complete Bearing Housing for Yamaha

This complete bearing housing is a replacement assembly for the Yamaha SX 195 1800, supporting the driveshaft bearing so the jet pump stays aligned and smooth through the RPM range.

Overview

The Complete Bearing Housing for Yamaha is a full assembly designed for the SX 195 1800 when the original housing wears out or the bearing fails. It carries the driveshaft bearing and holds alignment between the engine output and the jet pump. This Complete Bearing Housing fits owners and techs doing pump service on a boat with plenty of hours on it.

Built For Performance

• Complete assembly with bearing housing body ready for installation
• Machined bore sized for the driveshaft bearing fit
• Sealing surfaces designed to keep water out of the bearing cavity
• Mounting points match the factory bolt pattern
• Balanced housing body helps reduce driveline vibration

Fits These Machines

• for Yamaha SX 195 1800 (2017-2026)

On-The-Job Use

• Replacing a noisy or seized driveshaft bearing housing
• Scheduled pump maintenance on high-hour boats
• Rebuilding a jet pump after water intrusion
• Seasonal pre-launch driveline inspection

Specs At A Glance

Good To Know

Q: Does this housing come with the bearing installed? A: It is listed as a complete bearing housing assembly, so confirm bearing inclusion with the seller before ordering. Some assemblies ship with the bearing pressed in and others as a bare housing.

Q: How do I know it fits my boat? A: Match your model year against the 2017-2026 range listed and check your serial number. Driveline parts can change between production runs, so verify before purchase.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.