Complete Cylinder Head & Full Gasket Kit for 3TNV70 John Deere Gator XUV 850D

Complete Cylinder Head & Full Gasket Kit for John Deere Gator XUV 850D

This complete cylinder head and full gasket kit services the 3TNV70 diesel engine in the John Deere Gator XUV 850D, restoring proper compression and sealing after head warpage, gasket failure, or a top-end rebuild.

Overview

This complete cylinder head and full gasket kit is a direct-fit assembly for the 3TNV70 engine used in the John Deere Gator XUV 850D. The kit supplies the loaded cylinder head plus the gaskets and seals needed to complete a top-end repair in one order. It suits owners and shops handling a warped head, blown head gasket, or full engine refresh on this utility vehicle.

Built For Performance

• Complete cylinder head assembly ready for installation on the 3TNV70 engine
• Full gasket kit includes head gasket and top-end seals for a complete reseal
• Machined head surface for proper sealing against the block deck
• Cast construction matched to the 3TNV70 three-cylinder diesel layout
• Kit format reduces the need to source individual gaskets separately

Fits These Machines

• for John Deere Gator XUV 850D
• for machines running the 3TNV70 diesel engine

On-The-Job Use

• Top-end rebuild after head gasket failure
• Repair of warped or cracked cylinder heads
• Routine engine refresh on high-hour utility vehicles

Specs At A Glance

Good To Know

Q: Does this kit include the head bolts? A: The listing covers the cylinder head and full gasket kit only. Check your service manual for torque-to-yield bolts that should be replaced during assembly.

Q: Can I install this on a cold engine? A: Install per the 3TNV70 service procedure with the engine cold. Verify head flatness and clean the block deck before torquing the head in sequence.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.