Connecting Rod for Arctic Cat F8 800 cc 2007-2008 LXR Sno-Pro

Connecting Rod for Arctic Cat F8

This connecting rod is a precision-machined engine component that connects the piston to the crankshaft in Arctic Cat F8 800 cc snowmobiles, converting combustion force into crankshaft rotation.

Overview

This connecting rod is built for the Arctic Cat F8 800 cc engine found in LXR and Sno-Pro models. As a critical part of the rotating assembly, the connecting rod must hold up under high rpm and repeated combustion loads. It suits riders and mechanics performing top or bottom end engine work.

Built For Performance

• Machined from high-strength steel for dependable load capacity
• Precision bore tolerances on the big end and small end
• Balanced design to reduce vibration at high rpm
• Manufactured to match OEM connecting rod dimensions for direct fitment
• Surface finished for smooth bearing and wrist pin operation

Fits These Machines

• for Arctic Cat F8 800 cc 2007
• for Arctic Cat F8 800 cc 2008
• for Arctic Cat F8 LXR
• for Arctic Cat F8 Sno-Pro

On-The-Job Use

• Top and bottom end engine rebuilds on F8 800 cc sleds
• Replacing a bent or seized rod after engine failure
• Crankcase assembly during restoration or race prep
• Seasonal maintenance for high-mileage trail machines

Specs At A Glance

Good To Know

Q: Does this rod come with bearings? A: Bearings are typically sold separately unless stated otherwise. Check your engine rebuild kit to confirm whether big end and small end bearings are already included.

Q: Can I install this rod without machining the crank? A: Crank work is often required during a rod replacement, so have the crankshaft inspected and trued by a qualified shop before assembly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.