Connecting Rod Kit for Kawasaki SX 550 1982-1995

Connecting Rod Kit for Kawasaki SX 550

This connecting rod kit is a replacement crankshaft rod assembly for the Kawasaki SX 550, built to restore bottom-end integrity on 1982 through 1995 models.

Overview

This connecting rod kit for Kawasaki SX 550 delivers the rods, bearings, and pins needed to rebuild a worn or seized crankshaft assembly. Riders and shops turn to this kit when a 1982 to 1995 SX 550 needs fresh bottom-end components. Each kit is assembled for the SX 550 so the rebuild goes back together with matched parts.

Built For Performance

• Forged steel connecting rods for high-torque two-stroke loads
• Caged needle bearings for smooth rod-to-crank rotation
• Precision-ground crank pins for consistent bearing fit
• Thrust washers included for proper side clearance
• Balanced rod sets to limit vibration at wide-open throttle

Fits These Machines

• for Kawasaki SX 550 (1982-1995)
• for Kawasaki JS 550
• for Kawasaki 550 SX

On-The-Job Use

• Bottom-end rebuilds after a rod bearing failure
• Crankshaft refresh during a top-end service
• Restoring older SX 550 stand-up skis for seasonal use
• Shop-level engine overhauls on 1982 to 1995 models

Specs At A Glance

Good To Know

Q: Does this kit service both rods? A: Connecting rod kits for the SX 550 are commonly supplied as matched sets so both rods share the same balance and wear characteristics. Confirm the contents listing before ordering.

Q: Can I install this without splitting the cases? A: Connecting rod replacement requires splitting the crankcase and pressing the crankshaft apart. This job is best handled by a shop with the right press and alignment tools.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.