Connecting Rod Kit for Sea-Doo RX 951 2000-2002

Connecting Rod Kit for Sea-Doo RX 951

This connecting rod kit is a replacement engine component set for the Sea-Doo RX 951, restoring the link between the crankshaft and piston so the engine can turn power into thrust on the water.

Overview

The connecting rod kit for Sea-Doo RX 951 delivers the critical link between crankshaft and piston on 951cc two-stroke marine engines. Built as a direct replacement, this connecting rod kit for Sea-Doo RX 951 keeps the rotating assembly turning true so the engine holds compression and power through the season. It is aimed at riders and shops rebuilding a worn or scored top end on a 2000 to 2002 RX.

Built For Performance

• Connecting rod sized for the 951cc two-stroke engine platform
• Kit includes rod, bearing, and needed assembly hardware
• Machined to support high rpm marine use
• Balanced construction that helps reduce vibration at speed
• Designed to match the factory rod dimensions for a drop-in rebuild

Fits These Machines

• for Sea-Doo RX 951, 2000
• for Sea-Doo RX 951, 2001
• for Sea-Doo RX 951, 2002

On-The-Job Use

• Top end rebuilds on the 951cc engine
• Crankshaft and piston reassembly after a seizure
• Routine service on higher hour RX machines
• Race and recreation rebuilds needing a fresh rod
• Shop repairs on 2000 to 2002 RX watercraft

Specs At A Glance

Good To Know

Q: Do I need to replace both rods at once? A: It is good practice to inspect all rods during a rebuild and replace them as a set when wear is found, since they share the same service life.

Q: Does this kit include the bearing? A: Kits of this type typically ship with the rod bearing and small end hardware, so confirm the contents against your engine before assembly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.