Control Arm & Ball Joint Assembly Set-Front LH & RH Upper Forward for Audi & VW

Control Arm & Ball Joint Assembly Set for Audi & VW

This front upper forward control arm and ball joint assembly set provides the pivot points and mounting hardware needed to restore proper front suspension geometry on compatible Audi and Volkswagen models.

Overview

This control arm and ball joint assembly set replaces worn front upper forward components on compatible Audi and VW vehicles. Each assembly in the set combines the control arm and integrated ball joint for a direct-fit installation. Designed for both left and right hand sides, this set is intended for drivers addressing clunks, uneven tire wear, or loose steering feel.

Built For Performance

• Integrated ball joint pressed into each control arm for simplified installation
• Stamped steel arm construction built to withstand road vibration and load
• Left and right hand assemblies included for a complete front upper refresh
• Forward position design matches original mounting geometry
• Corrosion-resistant finish on arm surfaces

Fits These Machines

• for Audi models requiring front upper forward control arm assemblies
• for Volkswagen models requiring front upper forward control arm assemblies

On-The-Job Use

• Front suspension repair on daily-driven passenger cars
• Restoring steering precision after bushing and joint wear
• Routine front-end rebuilds during alignment service

Specs At A Glance

Good To Know

Q: Do I need an alignment after installing these control arms? A: Yes, a professional alignment is recommended after replacing front suspension components to ensure correct camber and toe settings.

Q: Are ball joints included with these control arms? A: Yes, each assembly in this set includes an integrated ball joint for the front upper forward position.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.