Control Arm & Ball Joint-Front Right Side Upper for Select VW & Audi-8D0407506H
Control Arm & Ball Joint-Front Right Side Upper for Select VW & Audi-8D0407506H
Couldn't load pickup availability
Control Arm & Ball Joint for Volkswagen & Audi - Front Right Upper
This front right upper control arm and ball joint assembly replaces the worn linkage on select Volkswagen and Audi models, restoring proper suspension geometry and steering response and cross-referencing OEM 8D0407506H.
Overview
This control arm and ball joint assembly is a direct-fit front right upper suspension component for select Volkswagen and Audi vehicles. It connects the spindle to the chassis, keeping camber and caster within spec while the integrated ball joint allows smooth articulation. A solid choice for drivers chasing vague steering, uneven tire wear, or clunking over bumps.
Built For Performance
- Integrated ball joint pressed into the arm for a complete bolt-on replacement
- Stamped steel arm construction built to handle road vibration and load
- Pre-installed dust boot protects the joint from dirt and moisture
- Precision-machined mounting points for an accurate fit
- Corrosion-resistant finish extends service life
Fits These Machines
- for Volkswagen Passat (B5 platform)
- for Audi A4 (B5 platform)
- for Audi A6 (C5 platform)
- for Volkswagen Beetle (where applicable)
On-The-Job Use
- Front suspension rebuilds after worn bushings or a torn ball joint boot
- Alignments where camber or caster cannot be brought back into spec
- Routine maintenance on higher-mileage Volkswagen and Audi cars
- Restoring steering feel after clunking or wandering develops
Specs At A Glance
| Part Number(s) | 8D0407506H |
| Position | Front Right, Upper |
| Type | Control Arm with Ball Joint |
| Material | Stamped Steel |
Good To Know
Q: Do I need an alignment after installing this control arm? A: Yes, replacing a control arm changes suspension geometry, so a professional alignment should follow installation to protect tire life and handling.
Q: Can I replace just one side? A: It can be done, but matching both sides is recommended when the opposite arm shows similar wear so the front end stays balanced.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
