Control Arm For Mercedes C320 2003-2005 Front Left Side Lower With Ball Joint

Control Arm for Mercedes C320

This front left lower control arm with an integrated ball joint replaces the worn suspension link on 2003 to 2005 Mercedes C320 models, restoring proper wheel alignment and steering response.

Overview

This front left lower control arm is a direct replacement suspension component for the Mercedes C320 from 2003 through 2005. The control arm connects the chassis to the wheel hub, holding camber and caster in spec while the included ball joint allows smooth steering articulation. It suits owners and shops replacing a bent, rusted, or bushing-worn arm on a daily driver or project car.

Built For Performance

• Lower control arm assembly with pre-installed ball joint for a complete bolt-on replacement
• Stamped steel construction built to handle road shock and cornering loads
• Rubber bushings pressed in place to damp vibration and keep alignment stable
• Ball joint boot sealed to keep out dirt and moisture
• Front left side fitment matched to the factory mounting points

Fits These Machines

• for Mercedes C320 2003
• for Mercedes C320 2004
• for Mercedes C320 2005

On-The-Job Use

• Replacing a bent or corroded lower control arm after curb or pothole damage
• Restoring alignment after worn bushings cause uneven tire wear
• Routine front suspension refresh on higher-mileage C320 models
• Steering and handling repairs performed in a home garage or service bay

Specs At A Glance

Good To Know

Q: Does this control arm come with the ball joint already installed? A: Yes, the ball joint is included with the arm so the assembly can be mounted as one unit. Check that the ball joint stud and nut match your spindle before installation.

Q: Will I need an alignment after replacing this arm? A: Yes, a professional alignment is recommended after installing any lower control arm. The new bushings and joint will settle, so align the front end once the car is back on its wheels.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.