CR80 Right Handlebar Brake Lever for Honda CR80 & CR80RB 1996-1997

Right Handlebar Brake Lever for Honda CR80 and CR80RB

This right handlebar brake lever replaces the front brake lever on CR80 and CR80RB models, restoring crisp front brake actuation for riders keeping these Honda two-strokes on the track.

Overview

This right handlebar brake lever is made to fit the front brake perch on the CR80 and CR80RB, giving you back proper lever travel and braking control. It serves riders repairing crash damage, replacing a bent lever after a moto, or stocking a spare for a classic 80cc race bike. The lever swaps on with basic tools so you can get back on the track quickly.

Built For Performance

• Shaped to match the CR80 front brake perch and master cylinder mount
• Die-cast alloy build resists flex under hard braking
• Pivot bore sized for the factory lever pin and spring
• Lever blade contoured for consistent one-finger control
• Direct replacement for the original right handlebar brake lever
• Installs with standard hand tools

Fits These Machines

• for Honda CR80 1996
• for Honda CR80 1997
• for Honda CR80RB 1996
• for Honda CR80RB 1997

On-The-Job Use

• Replacing a lever bent in a moto crash
• Refreshing controls on a restored CR80 race bike
• Keeping a spare on hand for race day
• Restoring front brake feel on a used two-stroke purchase

Specs At A Glance

Good To Know

Q: Is this lever a match for both the CR80 and CR80RB front brake? A: This right handlebar brake lever is listed for the CR80 and CR80RB front brake perch. Confirm the perch and master cylinder on your bike before ordering.

Q: Can I reuse the pivot pin and spring from my old lever? A: The original pivot pin and return spring are normally transferred over during installation. Check them for wear and replace if needed.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.