Crankshaft Crank Oil Seal Kit for Arctic Cat ZR 600 ZR600 1998-1999

Crankshaft/Crank Oil Seal Kit for Arctic Cat ZR 600

This crankshaft oil seal kit for Arctic Cat ZR 600 snowmobiles provides replacement crank seals to reseal the engine bottom end and prevent air leaks.

Overview

This crankshaft oil seal kit for Arctic Cat ZR 600 models is built to replace worn crank seals that cause lean running and oil loss. A fresh set of seals restores crankcase sealing so the engine holds pressure and runs clean. It suits 1998-1999 ZR600 owners handling a bottom-end rebuild or routine refresh.

Built For Performance

• Complete kit covering the crankshaft seals needed for a full reseal
• Made to hold crankcase pressure under high-rpm two-stroke operation
• Direct replacement fit for factory seal positions
• Resists oil, fuel, and heat exposure inside the crankcase
• Helps eliminate lean conditions that can damage pistons

Fits These Machines

• for Arctic Cat ZR 600 (1998-1999)
• for Arctic Cat ZR600

On-The-Job Use

• Bottom-end rebuilds and crank service on ZR 600 engines
• Correcting air leaks that cause erratic idle or lean jetting
• Refreshing a high-mileage trail sled before the season
• Shop repairs or garage DIY engine projects
• Preventive maintenance during top-end teardown

Specs At A Glance

Good To Know

Q: Will these seals fix a lean-running condition? A: Leaking crank seals let air into the crankcase and cause lean running, so replacing them often corrects that symptom. Q: Are these seals sold individually or as a set? A: This listing is a kit, so it includes the crankshaft seals needed for one engine reseal.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.