Crankshaft Oil Seal Kit for Sea-Doo SPI 580 1993-1996

Crankshaft Oil Seal Kit for Sea-Doo SPI 580

This crankshaft oil seal kit for Sea-Doo SPI 580 supplies the seals required to reseal the crankcase on 1993 through 1996 580 engine work.

Overview

This crankshaft oil seal kit for Sea-Doo SPI 580 contains the seals used to refresh the crankshaft sealing surfaces on 1993 to 1996 580 models. It suits riders and mechanics rebuilding or resealing a lower end. The kit restores a tight seal so oil stays in and air leaks stay out.

Built For Performance

• Seals sized for the 580 crankshaft and crankcase assembly
• Designed to hold crankcase pressure and keep oil contained
• Resists fuel, oil, and heat exposure in two-stroke service
• Suits full rebuilds and seal-only repair jobs
• Direct replacement for worn or leaking original seals

Fits These Machines

• for Sea-Doo SPI 580, 1993
• for Sea-Doo SPI 580, 1994
• for Sea-Doo SPI 580, 1995
• for Sea-Doo SPI 580, 1996

On-The-Job Use

• Crankcase reseal during a top or bottom end rebuild
• Fixing oil seepage and air leaks around the crank seals
• Routine lower-end refresh on older 580 machines
• Shop and home garage repair of a leaking two-stroke engine

Specs At A Glance

Good To Know

Q: What does this kit seal? A: It seals the crankshaft where it exits the crankcase to stop oil loss and air leaks. Both sides should be addressed together during a rebuild.

Q: Do I need any special tools? A: Seal removal and install typically need a puller and a suitable driver to seat the new seals square. Follow the service manual torque and installation steps for the 580 engine.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.