CV Joint Fast Boot Kit Front OR Rear for Polaris Ranger 400 4x4 2010-2014

CV Joint Fast Boot Kit for Polaris

This CV joint fast boot kit fits the front or rear of Polaris Ranger 400 4x4 models from 2010 to 2014, protecting the CV joint from contaminants and grease loss.

Overview

The CV joint fast boot kit is a direct replacement boot for Polaris Ranger 400 4x4 ATVs built between 2010 and 2014. It covers the CV joint on either the front or rear axle, keeping grease in and dirt out. This CV joint fast boot kit is designed for Polaris owners needing a quick repair after a torn boot.

Built For Performance

• Made from tough neoprene that resists tearing and ozone
• Features a fast‑install split design that reduces removal time
• Includes boot, bands, and grease packet for a complete kit
• Tested for flexibility in extreme cold and heat
• Rated for OEM‑equivalent service life

Fits These Machines

• for Polaris Ranger 400 4x4 (2010‑2014)

On‑The‑Job Use

• Replacing a torn CV boot discovered during routine inspection
• Performing axle service on Polaris Ranger 400 after off‑road use
• Restoring protection to the CV joint to prevent premature wear

Specs At A Glance

Good To Know

Q: Is this boot designed for the front or rear axle? A: It fits both front and rear positions on the Ranger 400 4x4; just confirm the axle diameter matches.

Q: Can I install this boot without removing the axle shaft? A: The fast‑boot design allows installation on the vehicle without full axle removal in many cases.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.