Cylinder Head Stud 208-4701 For Honda Acura K20 K24 K SeriesK Swap RSX Si

Cylinder Head Stud for Honda Acura

These cylinder head studs clamp the cylinder head to the engine block to prevent head gasket failure, referencing part number 208-4701.

Overview

This Cylinder Head Stud set for Honda Acura engines provides exceptional clamping force to prevent cylinder head lifting under high-RPM conditions. Replacing factory bolts with this Cylinder Head Stud set ensures a reliable block-to-head seal even under extreme combustion pressures. Performance builders performing engine swaps trust this Cylinder Head Stud set for maximum assembly strength.

Built For Performance

• Manufactured from premium-grade steel alloy for maximum tensile strength
• Thread-rolled after heat treatment to ensure superior fatigue resistance
• Provides consistent, even clamping force across the head gasket area
• Precision ground flat washers and hex nuts included for installation

Fits These Machines

• for Honda K20 Engines
• for Honda K24 Engines
• for Honda Civic Si
• for Acura RSX

On-The-Job Use

• Securing the cylinder head during K-Series engine builds and swaps
• Preventing head gasket failure on turbocharged or supercharged engines
• Rebuilding race engines that undergo extreme thermal cycling

Specs At A Glance

Good To Know

Q: Should these studs be torqued using engine oil or a specialty lube? A: Always use assembly lubricant on the threads and washers to obtain accurate torque readings during installation.

Q: Are these head studs reusable after an engine tear-down? A: Unlike stretch-to-yield factory bolts, these high-quality studs can be reused if they are undamaged and within stretch limits.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.