Cylinder Sleeve for Sea-Doo Spark TRIXX 1Up 900 2024-2026

Cylinder Sleeve for Sea-Doo Spark TRIXX 1Up 900

This cylinder sleeve is a replacement engine component made for Sea-Doo Spark TRIXX 1Up 900 models from 2024 to 2026, designed to restore the cylinder bore surface inside the engine so the piston and rings can seal and move correctly again.

Overview

This cylinder sleeve for Sea-Doo Spark TRIXX 1Up 900 gives your engine a fresh bore surface when the original has been scored, worn, or damaged. It is a press-in sleeve intended for engine rebuild and reconditioning work, letting a qualified machinist bring the cylinder back to spec instead of replacing the whole jug assembly. It suits riders and shops rebuilding a 900 ACE powered Spark TRIXX 1Up who want a dependable cylinder sleeve rather than a complete replacement engine.

Built For Performance

• Press-in sleeve design made for cylinder reconditioning on the 900 ACE engine
• Restores a true bore surface for proper piston ring sealing
• Machined to accept final honing during the rebuild process
• Suits the Sea-Doo Spark TRIXX 1Up 900 platform from 2024 through 2026
• Intended for professional installation with proper heating and pressing equipment

Fits These Machines

• for Sea-Doo Spark TRIXX 1Up 900, 2024
• for Sea-Doo Spark TRIXX 1Up 900, 2025
• for Sea-Doo Spark TRIXX 1Up 900, 2026

On-The-Job Use

• Engine top-end rebuilds after bore scoring or seizure
• Shop reconditioning work before fitting a new piston and rings
• Restoring a used 900 ACE cylinder for a Spark TRIXX 1Up
• Routine overhaul during off-season maintenance

Specs At A Glance

Good To Know

Q: Does this sleeve come ready to install? A: A cylinder sleeve is typically pressed in and then honed to the correct clearance for the piston, so final fitting should be done by a machine shop or experienced engine builder.

Q: Can I replace just the sleeve? A: Yes, when the cylinder casting itself is still serviceable, pressing in a new cylinder sleeve is a common way to restore the bore without replacing the entire cylinder assembly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.