Cylinder Sleeve for Sea-Doo XP 580 Fits 1992 Models

Cylinder Sleeve for Sea-Doo XP 580

This cylinder sleeve is a replacement engine component made to fit the Sea-Doo XP 580 and restore proper bore geometry in the cylinder for consistent compression.

Overview

This cylinder sleeve is built as a direct-fit replacement for the Sea-Doo XP 580, giving the engine a fresh bore surface for pistons and rings to ride against. It is intended for riders and mechanics rebuilding a top end or salvaging a scored cylinder. The cylinder sleeve for Sea-Doo XP 580 helps return the motor to reliable, repeatable performance.

Built For Performance

• Precision-machined bore for accurate piston-to-wall clearance
• Durable cast iron construction built to handle high cylinder temperatures
• Designed to press into the original cylinder casting
• Restores compression lost to scoring or excessive wear
• Suited to rebuild and refresh work on the XP 580 engine

Fits These Machines

• for Sea-Doo XP 580
• for Sea-Doo XP 580 (1992)

On-The-Job Use

• Top-end rebuilds on the Sea-Doo XP 580
• Cylinder repair after scoring or seizure
• Routine engine refresh in a shop or home garage
• Restoring a vintage 1992 personal watercraft

Specs At A Glance

Good To Know

Q: Does this sleeve need to be machined after installation? A: Yes, a press-in cylinder sleeve typically requires boring and honing to final size after fitting so piston clearance matches spec.

Q: Can I install this without removing the engine? A: Cylinder sleeve work normally calls for pulling the cylinder, and pressing the sleeve in and out is best handled by a machine shop.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.