Douille Roller Arm Bushings for Ski-Doo MXZ 440 1997 2000

Roller Arm Bushings for Ski-Doo MXZ 440

These roller arm bushings are replacement suspension wear parts for the 1997 and 2000 Ski-Doo MXZ 440, restoring smooth pivot action in the rear skid.

Overview

These roller arm bushings are direct-fit replacement wear parts for the 1997 and 2000 Ski-Doo MXZ 440 snowmobile. They sit in the rear suspension arm pivots, cutting friction and keeping the skid cycling freely instead of binding. Riders and shops reach for fresh roller arm bushings when the old ones wear oval and the suspension starts to clunk.

Built For Performance

• Renews worn pivot points in the rear skid to cut slop and vibration
• Durable construction made to handle the loads of trail riding
• Keeps the roller arm moving smoothly through the full stroke
• Direct replacement for the factory bushing position on listed model years
• Sold as a pair so both sides of the arm are covered

Fits These Machines

• for Ski-Doo MXZ 440, 1997
• for Ski-Doo MXZ 440, 2000

On-The-Job Use

• Rear skid bushing service on the trail sled
• Pre-season suspension refresh before the snow flies
• Rebuilding a worn rear arm after a season of hard miles
• Shop and home-wrench repairs on the MXZ 440

Specs At A Glance

Good To Know

Q: How do I know if my bushings need replacing? A: Play at the roller arm pivot, a clunk over bumps, or oval-shaped old bushings are the usual signs. If the arm rocks without the shock moving, it is time for new ones.

Q: Do I need to press these in? A: Most roller arm bushings push or tap into the arm eye with light force, and a bench vise or a rubber mallet handles the job. Grease the bore and the bushing goes in easier.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.