Drive Shaft Bellow High Tension for Sea-Doo 3D DI 951 2006-2007

Drive Shaft Bellow (High Tension) for Sea-Doo

High tension drive shaft bellow for Sea-Doo 3D DI 951 models, a flexible rubber boot that seals the drive shaft passage and keeps water out of the hull while allowing shaft movement.

Overview

This high tension drive shaft bellow is a direct replacement seal for the Sea-Doo 3D DI 951, designed to protect the drive line from water intrusion. The bellow flexes with the shaft while maintaining a tight seal at the hull and engine interfaces. It is aimed at owners performing routine drive line maintenance or rebuilding a 2006 to 2007 Sea-Doo 3D DI 951.

Built For Performance

• High tension rubber construction resists tearing under repeated flexing
• Seals the drive shaft passage to keep water out of the hull
• Accommodates normal shaft movement without cracking
• Direct fitment for 2006 to 2007 Sea-Doo 3D DI 951 models
• Withstands continuous exposure to marine conditions

Fits These Machines

• for Sea-Doo 3D DI 951, 2006
• for Sea-Doo 3D DI 951, 2007

On-The-Job Use

• Drive line refresh during routine jet pump service
• Resealing the hull after shaft or bearing replacement
• Seasonal maintenance on personal watercraft
• Rebuild projects on older Sea-Doo watercraft

Specs At A Glance

Good To Know

Q: How do I know if my drive shaft bellow needs replacement? A: Look for cracks, hardening, or water pooling in the hull near the drive line, which indicate the bellow has lost its seal. Replacing it before it fails helps prevent water damage.

Q: Is the bellow difficult to install? A: Installation typically requires removing the drive shaft, so many owners do it alongside related drive line work. Inspect mating surfaces and fasteners during reassembly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.