Drive Shaft Bellow High Tension for Sea-Doo HX 720 1995-1997

Drive Shaft Bellow (High Tension) for Sea-Doo

The high tension drive shaft bellow for Sea-Doo HX 720 watercraft seals the driveshaft joint against water intrusion while flexing with the shaft under load.

Overview

This drive shaft bellow is a high tension replacement seal built for the Sea-Doo HX 720 from 1995 to 1997. It protects the drive shaft connection from water and debris while allowing the needed flex as the shaft turns. Riders performing driveline service on the HX 720 will find this bellow a direct fit wear item.

Built For Performance

• High tension rubber compound resists cracking and hardening over time
• Ribbed profile flexes with drive shaft movement without losing seal
• Keeps water and debris away from the drive shaft joint
• Designed to match the HX 720 driveline for a direct fit
• Holds up to marine grease and fuel exposure

Fits These Machines

• for Sea-Doo HX 720 (1995-1997)

On-The-Job Use

• Routine drive shaft service on personal watercraft
• Replacing a worn or torn bellow before water reaches the joint
• Driveline rebuilds that require removing the drive shaft
• Seasonal maintenance on older Sea-Doo HX 720 models

Specs At A Glance

Good To Know

Q: What causes a drive shaft bellow to fail? A: Heat, age, and constant flexing cause the rubber to harden and crack, which lets water reach the joint. Replacing it during routine service prevents bigger driveline damage.

Q: Can this bellow be installed without removing the engine? A: On most HX 720 models the drive shaft has to come out to access the bellow ends properly. Check your service manual for the correct procedure and torque specs.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.