Drive Shaft Bellow High Tension for Sea-Doo LRV DI 951 2002-2003

Drive Shaft Bellow (High Tension) for Sea-Doo

The high tension drive shaft bellow for Sea-Doo LRV DI 951 watercraft provides a flexible seal at the driveshaft connection point, keeping water out while allowing the shaft to articulate under load.

Overview

This drive shaft bellow is a high tension rubber seal designed for the Sea-Doo LRV DI 951 from 2002 to 2003. The bellow protects the drive shaft joint from water intrusion and debris, helping maintain smooth power transfer from the engine to the jet pump. It is a direct replacement wear item for riders performing routine driveline service on the LRV DI 951.

Built For Performance

• High tension rubber construction resists flex fatigue under repeated drive shaft movement
• Reinforced ribs maintain shape and sealing pressure through vibration and torque changes
• Seals the drive shaft joint against water intrusion during operation
• Direct fit design for the LRV DI 951 2002 to 2003 driveline
• Withstands exposure to fuel, oil, and marine grade lubricants

Fits These Machines

• for Sea-Doo LRV DI 951 (2002-2003)

On-The-Job Use

• Routine driveline maintenance on personal watercraft
• Replacing a cracked or hardened bellow before it fails on the water
• Driveshaft service when removing or reinstalling the engine
• Preventive upkeep on high hour Sea-Doo LRV DI 951 models

Specs At A Glance

Good To Know

Q: How often should a drive shaft bellow be replaced? A: Inspect the bellow during every driveline service and replace it any time it shows cracking, hardening, or tears. Age and heat cycles are the main causes of failure.

Q: Does this bellow require special tools to install? A: Installation typically involves removing the drive shaft and securing the bellow at both ends. Follow your service manual for torque values and sealant requirements.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.