Drive Shaft Bellow High Tension for Sea-Doo SPX 720 1996

Drive Shaft Bellow (High Tension) for Sea-Doo SPX 720

This high tension drive shaft bellow is a replacement rubber boot for the driveline of a 1996 Sea-Doo SPX 720, sealing the through-hull drive shaft opening against water intrusion and keeping the shaft joint protected from debris.

Overview

This drive shaft bellow for Sea-Doo SPX 720 models keeps water out of the hull where the drive shaft passes through, while allowing the shaft to flex under load. The high tension design suits the pressure and movement of the 720 driveline. It is a service replacement part for riders maintaining a 1996 SPX 720.

Built For Performance

• High tension rubber construction built to hold its shape under driveline movement
• Seals the through-hull opening to help keep bilge water out
• Flexible material absorbs shaft movement without cracking
• Direct replacement fitment for 1996 Sea-Doo SPX 720 models
• Protects the shaft joint from debris thrown up in the pump area

Fits These Machines

• for Sea-Doo SPX 720 1996

On-The-Job Use

• Drive shaft seal replacement during routine driveline service
• Bilge leak repair on older SPX 720 hulls
• Rebuilds after removing the engine or pump assembly
• Pre-season inspection of the through-hull driveline area

Specs At A Glance

Good To Know

Q: Does this bellow fit the 1996 SPX 720 only? A: The listing covers the 1996 SPX 720, but serial number changes can affect fitment, so confirm your hull number before ordering.

Q: Why choose a high tension bellow over a standard one? A: The high tension version is built for the added movement of the 720 driveline and is meant for the same mounting location as the original boot.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.