Drive Shaft Bellow Kit for Sea-Doo Spark 2Up 900 2015-2021

Drive Shaft Bellow Kit for Sea-Doo Spark 2Up 900

This drive shaft bellow kit seals the connection between the driveshaft and hull on 2015-2021 Sea-Doo Spark 2Up 900 watercraft, keeping water out of the driveline tunnel.

Overview

This drive shaft bellow kit is made for the 2015-2021 Sea-Doo Spark 2Up 900 platform, providing a flexible seal around the driveshaft where it passes through the hull. The bellow kit keeps water from entering the engine compartment while allowing the shaft to spin freely. It is built for personal watercraft owners doing routine driveline maintenance or replacing a cracked, hardened bellows.

Built For Performance

• Flexible rubber construction absorbs vibration and minor misalignment
• Seals the driveshaft passage to keep bilge water out of the engine bay
• Resists cracking and hardening from sun, salt, and fuel exposure
• Direct replacement for the factory bellow on the 900 ACE platform
• Includes components needed for a complete bellow service

Fits These Machines

• for Sea-Doo Spark 2Up 900 (2015-2021)

On-The-Job Use

• Routine driveshaft maintenance on 2015-2021 Spark 2Up 900
• Replacing a torn or hardened bellow after a season of riding
• Driveline service during impeller or wear ring work
• Post-storage inspection of the shaft seal area

Specs At A Glance

Good To Know

Q: Does this kit fit both Spark 2Up and 3Up models? A: This bellow kit is listed for the 2Up 900 platform, so verify your model and year before ordering. Checking your hull identification number is the safest way to confirm fit.

Q: How often should the bellow be replaced? A: Inspect the bellow at least once a season and replace it any time it shows cracks, stiffness, or tears. A worn bellow lets water into the engine bay and can lead to costly damage.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.