Dual Electric Cooling Fan Wiring Relay Kit 185 On 175 Off Thermostat 12V 40 Amp

Dual Electric Cooling Fan Wiring Relay Kit

This dual electric cooling fan wiring relay kit provides an automated electrical solution for managing radiator fans based on engine coolant temperature.

Overview

This Dual Electric Cooling Fan Wiring Relay Kit automates the cooling process by triggering fans at a specific temperature threshold to prevent engine overheating. Designed for 12V systems, this Dual Electric Cooling Fan Wiring Relay Kit ensures reliable current management for high-draw cooling components. Mechanics and automotive builders use this kit to maintain consistent operating temperatures during vehicle operation.

Built For Performance

• Dual 40 Amp relay capacity to handle high-amperage electrical draws from two fans.
• Thermostat switch activates fans at 185 degrees and deactivates them at 175 degrees.
• Pre-wired harness configuration simplifies the integration of dual fan setups.
• Compatible with standard 12V automotive electrical systems.
• High-temperature resistant wiring insulation designed for engine bay environments.

On-The-Job Use

• Managing radiator temperatures in custom performance vehicle builds.
• Integrating electric cooling fans into classic car restorations.
• Protecting vehicle electrical components from heat-induced failure during operation.
• Automating fan cycles in engine swap applications where OEM controls are absent.

Specs At A Glance

Good To Know

Q: Can this kit be used with a single cooling fan? A: Yes, while designed for dual fan configurations, it can effectively power and control a single high-flow fan if required.

Q: Where is the best location to install the thermostat sensor? A: The sensor should be installed in the cylinder head or engine block to ensure the most accurate reading of the engine coolant temperature.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.