Engine Air Cleaner Intake Hose Tube For 2014-2020 Mercedes-Benz GLA250 CLA250

Engine Air Cleaner Intake Hose Tube for Mercedes-Benz GLA250 / CLA250

This engine air cleaner intake hose tube channels filtered air from the air cleaner housing to the engine intake on 2014-2020 Mercedes-Benz GLA250 and CLA250 models.

Overview

This engine air cleaner intake hose tube replaces cracked, collapsed, or leaking original ducting to restore proper airflow and fuel metering. The engine air cleaner intake hose tube is molded to follow the factory routing, allowing a quick drop-in installation without modification. It fits the 2.0L turbocharged engines in the 2014-2020 Mercedes-Benz GLA250 and CLA250.

Built For Performance

• High-temperature oil-resistant rubber compound withstands sustained engine bay heat
• Internal spiral reinforcement prevents hose collapse under vacuum and turbo boost transitions
• Precision-molded shape mirrors OEM routing to avoid chafing against engine components
• Eliminates unmetered air leaks that can trigger fuel trim fault codes and power loss
• Smooth inner wall reduces airflow turbulence for consistent throttle response
• Compatible with factory air cleaner and turbo inlet connections using existing clamps

Fits These Machines

• for Mercedes-Benz GLA250 (2014-2020)
• for Mercedes-Benz CLA250 (2014-2020)

On-The-Job Use

• Replacing a torn intake hose that causes rough idle and stalling
• Restoring lost power and fuel economy after a split duct triggers a check engine light
• Scheduled maintenance when replacing the engine air filter on high-mileage vehicles
• Independent shop service for Mercedes-Benz GLA and CLA models requiring intake system repair
• DIY garage repair with basic hand tools and no special calibration needed

Good To Know

Q: Does this hose fit both the GLA250 and CLA250 regardless of drive configuration? A: This engine air cleaner intake hose tube fits all 2014-2020 Mercedes-Benz GLA250 and CLA250 models equipped with the 2.0L turbo engine, as the intake tract routing is identical across front-wheel and all-wheel-drive versions.

Q: Will I need to purchase new clamps separately? A: The hose is designed to work with the vehicle's original spring-type or worm-gear clamps; reuse your existing clamps if they are free of corrosion and still provide a tight seal.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.