ENGINE CARBURETOR RUBBER INTAKE REED BOOT For HONDA CRF250X CRF250R 2004-2019 US

Engine Carburetor Rubber Intake Reed Boot for HONDA

This engine carburetor rubber intake reed boot for HONDA seals the pathway between the carburetor and cylinder intake to prevent unmetered air from entering the combustion chamber.

Overview

The engine carburetor rubber intake reed boot for HONDA is designed to eliminate lean run issues caused by cracked or rotting intake boots. This engine carburetor rubber intake reed boot for HONDA ensures stable engine idle speeds and proper throttle response by maintaining an airtight seal. It is designed for dirt bike riders and racers seeking a durable replacement for a worn factory rubber intake.

Built For Performance

• Molded from high-density rubber to resist heat and fuel-induced cracking
• Thick mounting flanges prevent warping and vacuum leaks under heavy vibration
• Smooth internal bore design optimizes air-fuel mixture velocity into the intake
• Corrosion-resistant metal reinforcement rings ensure a secure clamp hold

Fits These Machines

• for HONDA CRF250X (2004-2019)
• for HONDA CRF250R (2004-2019)

On-The-Job Use

• Resolving hanging idles or hard starting caused by intake vacuum leaks
• Rebuilding the fuel intake tract during routine top-end maintenance
• Replacing dry-rotted rubber boots before trail rides or motocross races

Specs At A Glance

Good To Know

Q: Does this intake boot come with new mounting clamps? A: This is the rubber boot itself, designed to be used with the original factory clamps and hardware.

Q: What are the common signs of a failing intake boot? A: Visual cracks, dry rotting, or a hanging engine idle are common indicators that air is leaking through the boot.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.