Engine Crank Crankshaft Oil Seal Set for Husqvarna FE350 FE 350 2017-2024

Engine Crank/Crankshaft Oil Seal Set for Husqvarna FE350

This engine crank/crankshaft oil seal set is a direct-fit replacement seal kit for the Husqvarna FE350, designed to reseal the crankcase and crankshaft area so oil stays where it belongs.

Overview

This engine crank/crankshaft oil seal set is built to replace worn or leaking seals on the Husqvarna FE350 engine. It restores a tight seal at the crankshaft and crankcase, helping to prevent oil seepage and keep internal lubrication where it belongs. A practical pick for FE 350 owners doing a rebuild or chasing down a persistent leak.

Built For Performance

• Direct replacement for the factory crank and crankshaft oil seals
• Constructed from oil-resistant sealing material for long service life
• Designed to hold up under the heat and pressure of engine operation
• Precision sizing for a proper fit on the FE350 crank assembly
• Sold as a complete seal set for the crank/crankshaft area

Fits These Machines

• for Husqvarna FE350 (2017-2024)
• for Husqvarna FE 350 (2017-2024)

On-The-Job Use

• Engine rebuilds and top-end or bottom-end service
• Resealing a crankcase after splitting the cases
• Fixing oil leaks around the crankshaft area
• Routine maintenance on high-hour FE350 engines

Specs At A Glance

Good To Know

Q: What does this seal set do? A: It replaces the worn crank and crankshaft oil seals to stop leaks and keep oil sealed inside the engine. Q: Do I need to split the cases to install it? A: Some seals can be replaced with the engine assembled, but crankshaft seals often require case splitting, so check your service manual first.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.