Skip to product information
1 of 1

Engine Crank Seals for Polaris Cyclone 250 1987

Engine Crank Seals for Polaris Cyclone 250 1987

Regular price $24.49
Regular price Sale price $24.49
Sale Sold out
Quantity

Engine Crank Seals for Polaris Cyclone 250

Engine crank seals for the 1987 Polaris Cyclone 250 that seal the crankshaft ends to hold crankcase pressure and keep oil where it belongs.

Overview

These engine crank seals are made for the 1987 Polaris Cyclone 250 and seal the crankshaft at the case and bearing journals. Good crank seals keep the crankcase sealed so the engine holds pressure and lubrication stays put. A set like this suits riders rebuilding a top or bottom end or chasing a leak-down failure on a classic Polaris Cyclone 250.

Built For Performance

  • Seals the crankshaft ends against crankcase pressure loss
  • Keeps oil contained at the crank journals
  • Rubber lip construction for a consistent sealing face
  • Vehicle-specific sizing for the 1987 Polaris Cyclone 250

Fits These Machines

  • for Polaris Cyclone 250, 1987

On-The-Job Use

  • Bottom-end rebuilds and crankcase resealing
  • Curing oil leaks at the crank ends
  • Leak-down test repairs on older Polaris engines
  • Restoring a 1987 Cyclone 250 for trail or show use

Specs At A Glance

Application 1987 Polaris Cyclone 250
Component Engine crank seals

Good To Know

Q: Should crank seals be replaced as a set? A: Yes, replacing both crank seals at once is standard practice since a leak on either side causes the same running issues.

Q: Do I need to split the cases to install them? A: On many two-stroke engines crank seals can be replaced from the outside, but check your Cyclone 250 service manual for the exact procedure.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details