Engine Cylinder Head Bolts Set for Chevrolet C1500 C2500 Cadillac Escalade 5.7L

Engine Cylinder Head Bolts Set for Chevrolet and Cadillac

This engine cylinder head bolts set secures the cylinder heads to the engine block on 5.7L applications, helping maintain proper clamping force and a reliable head gasket seal.

Overview

This engine cylinder head bolts set provides the fasteners needed to reinstall cylinder heads on 5.7L GM engines. Each bolt is designed to deliver consistent clamping load so the head gasket stays sealed under heat and pressure. The set suits rebuilders and mechanics servicing Chevrolet C1500, C2500, and Cadillac Escalade models.

Built For Performance

• Manufactured from hardened steel for high tensile strength
• Threads cut to precise tolerances for consistent torque readings
• Designed for 5.7L cylinder head applications
• Set supplies the full count of bolts for one engine
• Coating resists corrosion during service

Fits These Machines

• for Chevrolet C1500 5.7L
• for Chevrolet C2500 5.7L
• for Cadillac Escalade 5.7L

On-The-Job Use

• Top-end engine rebuilds and head gasket replacement
• Cylinder head removal and reinstallation
• Workshop and garage engine service

Specs At A Glance

Good To Know

Q: Are these torque-to-yield bolts? A: Many 5.7L cylinder head bolts are designed to stretch and are replaced after one use, so follow the service procedure for your engine. A: Confirm the required torque sequence and values in your factory service manual before installation.

Q: Should I replace the head gasket at the same time? A: Yes, a new head gasket is normally installed whenever the cylinder heads are removed. Inspect bolt holes and clean threads before fitting the new set.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.