EU0-U7252-01-00 Throttle Cable for Yamaha Wave Blaster 700 1993-1995

Throttle Cable for Yamaha Wave Blaster 700

This throttle cable for Yamaha Wave Blaster 700 watercraft replaces OEM part EU0-U7252-01-00 and restores crisp, consistent throttle response.

Overview

This throttle cable is a direct replacement for the Yamaha Wave Blaster 700 personal watercraft covering the 1993 to 1995 model years. It links the handlebar throttle lever to the carburetor for smooth, predictable input. It is aimed at riders who need a dependable replacement throttle cable for Yamaha Wave Blaster 700 machines without going through an OEM-branded part.

Built For Performance

• Cross-references OEM part number EU0-U7252-01-00
• Low-friction inner cable for smooth lever travel
• Protective outer sheath guards against abrasion and moisture
• Pre-formed end fittings match stock throttle lever and carburetor connections
• Constructed for repeated use in a wet marine environment
• Direct-fit length matched to the Wave Blaster 700 chassis

Fits These Machines

• for Yamaha Wave Blaster 700, 1993
• for Yamaha Wave Blaster 700, 1994
• for Yamaha Wave Blaster 700, 1995

On-The-Job Use

• Replacing a frayed or stuck throttle cable on a Wave Blaster 700
• Routine service alongside carburetor cleaning or rebuilds
• Bringing a project or high-hour watercraft back to reliable running condition
• Pre-season maintenance before the craft goes back on the water

Specs At A Glance

Good To Know

Q: Does this cable fit models outside the listed years? A: Fitment is based on the EU0-U7252-01-00 part number and the years shown, so verify your machine's part number before ordering.

Q: Is this an original Yamaha part? A: This is an aftermarket replacement cable for Yamaha watercraft and is not an original brand part. It is cross-referenced to OEM number EU0-U7252-01-00 for identification.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.