Exhaust Gasket Kit for Husqvarna FE 501 FE 501S 2014-2019 FE501 FE501S
Exhaust Gasket Kit for Husqvarna FE 501 FE 501S 2014-2019 FE501 FE501S
Couldn't load pickup availability
Exhaust Gasket Kit for Husqvarna FE 501 and FE 501S
This exhaust gasket kit for Husqvarna FE 501 and FE 501S supplies the sealing components needed to reseal the exhaust joints on 2014 through 2019 FE501 and FE501S machines and prevent leaks at the header, midpipe and muffler connections.
Overview
This exhaust gasket kit for Husqvarna FE 501 and FE 501S is a direct-fit sealing set built for riders servicing the exhaust on their 2014 to 2019 FE501 or FE501S. It replaces worn, crushed or blown gaskets so the exhaust seals tight, cuts leakage and helps the engine breathe as intended. Suited to home mechanics and shops handling routine servicing or exhaust repairs on the FE 501 platform.
Built For Performance
- Complete gasket set covering the exhaust joints on the FE501
- Heat-resistant material engineered for high exhaust gas temperatures
- Pre-formed to match factory sealing surfaces for a drop-in fit
- Restores a tight seal to reduce exhaust leaks and rattles
- Helps maintain correct backpressure for consistent engine response
- Suited to routine servicing and exhaust rebuilds
Fits These Machines
- for Husqvarna FE 501, 2014-2019
- for Husqvarna FE 501S, 2014-2019
On-The-Job Use
- Resealing the exhaust after a top-end rebuild or valve service
- Replacing blown or crushed gaskets on a high-hour FE501
- Trailside or workshop exhaust repairs after a knock or drop
- Refreshing the exhaust during routine maintenance intervals
Specs At A Glance
| Part Number(s) | FE501, FE501S |
| Type | Exhaust gasket kit |
| Fitment | for Husqvarna FE 501 and FE 501S, 2014-2019 |
Good To Know
Q: Do I need to replace the exhaust gaskets every time I remove the exhaust? A: Gaskets crush to seal and often will not reseal once disturbed, so fitting a fresh kit whenever the exhaust is removed is the reliable choice.
Q: Will this kit fit both the header and muffler joints? A: The kit is intended to reseal the exhaust connections on the FE501 and FE501S, so verify the joint count on your machine against the supplied components before installation.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
