Exhaust Gasket Spring Kit for Ski-Doo MXZ 600 E-Tec 2016-2018 Snowmobile

Exhaust Gasket and Spring Kit for Ski-Doo MXZ 600 E-Tec

This exhaust gasket and spring kit for Ski-Doo MXZ 600 E-Tec supplies the sealing and retaining hardware required to keep the exhaust system mounted correctly on 2016-2018 models.

Overview

This exhaust gasket and spring kit for Ski-Doo MXZ 600 E-Tec gives you the seals and tension springs needed for a secure exhaust connection. The exhaust gasket and spring kit is built for riders servicing their sled after engine work or replacing tired sealing parts. Each component matches the MXZ 600 E-Tec exhaust layout so the pipe stays sealed against the cylinder and muffler joints.

Built For Performance

• Gasket material made to seal under high exhaust temperatures
• Springs engineered to hold consistent tension at the exhaust joints
• Direct-fit shapes matched to the MXZ 600 E-Tec exhaust flanges
• Helps prevent blow-by leaks that reduce engine performance
• Combined kit delivers sealing and retaining parts together

Fits These Machines

• for Ski-Doo MXZ 600 E-Tec 2016
• for Ski-Doo MXZ 600 E-Tec 2017
• for Ski-Doo MXZ 600 E-Tec 2018

On-The-Job Use

• Exhaust reassembly after top-end or engine repair
• Scheduled replacement of heat-cycled or compressed gaskets
• Correcting exhaust leaks and loose spring mounts on the trail
• Pre-season maintenance before winter riding

Specs At A Glance

Good To Know

Q: When should the exhaust gasket and springs be replaced? A: Swap the gasket any time the exhaust is removed and change the springs when they lose tension or corrode. New seals and springs keep the exhaust sealed and firmly attached.

Q: Does this kit cover all three model years listed? A: Yes, the listing covers the 2016, 2017, and 2018 MXZ 600 E-Tec. Verify your model and serial number before ordering to confirm the fit.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.