Exhaust Temp Sensor for Ski-Doo Expedition LE 600 E-Tec 2014-2015
Exhaust Temp Sensor for Ski-Doo Expedition LE 600 E-Tec 2014-2015
Couldn't load pickup availability
Exhaust Temperature Sensor for Ski-Doo Expedition LE 600 E-Tec
This exhaust temperature sensor, an OEM cross-reference 600 E-Tec component, monitors exhaust gas temperature on 2014-2015 Ski-Doo Expedition LE 600 E-Tec snowmobiles to help the engine management system protect the powerplant.
Overview
This exhaust temp sensor for Ski-Doo Expedition LE 600 E-Tec reads exhaust gas temperature so the engine control module can adjust fueling and guard against overheating. The exhaust temperature sensor is a direct replacement for the factory unit on 2014-2015 models. It suits riders and mechanics servicing the 600 E-Tec exhaust temperature sensor circuit.
Built For Performance
- Direct replacement for the factory exhaust temperature sensor on 2014-2015 Ski-Doo Expedition LE 600 E-Tec
- Constructed to withstand continuous high-temperature exhaust gas exposure
- Threaded mounting matches the stock exhaust port for straightforward installation
- Electrical connector designed to plug into the factory harness
- Provides accurate temperature feedback to the engine control module
Fits These Machines
- for Ski-Doo Expedition LE 600 E-Tec, 2014
- for Ski-Doo Expedition LE 600 E-Tec, 2015
On-The-Job Use
- Replacing a failed or inaccurate exhaust temperature sensor during engine service
- Restoring proper temperature monitoring on the 600 E-Tec engine
- Preventive maintenance on high-mileage Expedition LE snowmobiles
- Diagnostic repair when the ECU logs an exhaust temperature code
Specs At A Glance
| Part Number(s) | 600 E-Tec |
| Type | Exhaust Temperature Sensor |
| Compatible Engine | 600 E-Tec |
Good To Know
Q: How do I know if my exhaust temperature sensor has failed? A: A failed sensor often triggers an engine code, poor running, or reduced power on your 600 E-Tec. Replacing it restores accurate temperature readings to the ECU.
Q: Does this sensor require any special tools to install? A: Installation uses standard hand tools to remove the old sensor and thread in the new one. Confirm the connector matches your factory harness before ordering.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
