Exhaust Temp Sensor for Ski-Doo GSX LE 600 HO E-Tec 2009-2011
Exhaust Temp Sensor for Ski-Doo GSX LE 600 HO E-Tec 2009-2011
Couldn't load pickup availability
Exhaust Temperature Sensor for Ski-Doo
This exhaust temperature sensor monitors EGT readings on 2009-2011 Ski-Doo GSX LE 600 HO E-Tec snowmobiles, helping the engine management system maintain proper fueling and protect against overheating.
Overview
This exhaust temp sensor for Ski-Doo is a direct replacement component for the GSX LE 600 HO E-Tec. It reads exhaust gas temperature and sends that signal to the ECM so fuel delivery and timing stay within safe limits. A smart spare for riders who maintain their own sleds.
Built For Performance
- Monitors exhaust gas temperature for accurate ECM feedback
- Threaded probe designed for direct installation into the exhaust pipe
- Built to withstand high-temperature two-stroke exhaust conditions
- Plug-and-play connector matches the factory wiring harness
- Helps protect the engine from lean-running heat damage
Fits These Machines
- for Ski-Doo GSX LE 600 HO E-Tec 2009
- for Ski-Doo GSX LE 600 HO E-Tec 2010
- for Ski-Doo GSX LE 600 HO E-Tec 2011
On-The-Job Use
- Trail riding where consistent engine temps matter
- Replacing a failed or erratic factory exhaust temp sensor
- Routine tune-ups and top-end service
- Diagnosing EGT-related fault codes
Specs At A Glance
| Part Type | Exhaust Temperature Sensor |
| Engine | 600 HO E-Tec |
| Position | Exhaust Pipe |
Good To Know
Q: Does this sensor require any tuning after install? A: No tuning is needed; the ECM reads it automatically once plugged in. Clear any stored fault codes and test ride to confirm normal operation.
Q: Can I ride with a faulty exhaust temp sensor? A: A failed sensor can cause poor fueling or a limp mode, so replacing it promptly protects the engine. Continued riding with a bad reading risks heat damage.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
