Skip to product information
1 of 1

Exhaust Temp Sensor for Ski-Doo Skandic SWT 600 HO E-Tec 2012 Snowmobile

Exhaust Temp Sensor for Ski-Doo Skandic SWT 600 HO E-Tec 2012 Snowmobile

Regular price $197.99
Regular price Sale price $197.99
Sale Sold out
Quantity

Exhaust Temp Sensor for Ski-Doo

This exhaust temperature sensor monitors exhaust gas temperature on Ski-Doo snowmobiles and relays that reading to the engine management system.

Overview

This exhaust temp sensor is a direct-fit replacement for the factory exhaust temperature sensor on Ski-Doo snowmobiles. The exhaust temperature sensor helps the ECU manage fuel delivery and protect the engine from overheating by reporting real-time exhaust gas temperature. It is a practical choice for riders servicing a 2012 Skandic SWT 600 HO E-Tec who need a reliable replacement sensor.

Built For Performance

  • Threaded probe designed to seat into the exhaust stream for accurate gas temperature readings
  • Weather-resistant connector and wiring suited to cold, wet snowmobile environments
  • Consistent signal output to support proper ECU fuel and timing control
  • Compact body sized for tight exhaust manifold mounting points
  • Built to withstand constant high-temperature exhaust exposure

Fits These Machines

  • for Ski-Doo Skandic SWT 600 HO E-Tec, 2012

On-The-Job Use

  • Replacing a failed or inaccurate exhaust temperature sensor during engine service
  • Restoring proper ECU readings after a sensor fault code appears
  • Routine maintenance on 600 HO E-Tec engines
  • Trailside or garage repair of exhaust temperature monitoring faults

Specs At A Glance

Part Type Exhaust Temperature Sensor
Engine 600 HO E-Tec
Model Year 2012
Vehicle for Ski-Doo Skandic SWT

Good To Know

Q: Will this sensor clear an exhaust temperature fault code? A: Replacing a faulty exhaust temperature sensor often resolves the related fault code once the ECU sees a normal signal again. Always confirm the code source before replacing parts.

Q: Does the sensor need any special calibration after install? A: These sensors are typically plug-and-play with no calibration required. Check the connector and wiring for damage before installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details