Exhaust Temp Temperature Sensor for Polaris RMK 700 2008-2010
Exhaust Temp Temperature Sensor for Polaris RMK 700 2008-2010
Couldn't load pickup availability
Exhaust Temperature Sensor for Polaris RMK 700
This exhaust temperature sensor for Polaris RMK 700 snowmobiles from 2008 through 2010 monitors exhaust gas temperature so the engine management system can keep fueling and timing in a safe range.
Overview
This exhaust temp sensor is a direct-fit replacement for the stock temperature probe on Polaris RMK 700 models built from 2008 to 2010. The sensor reads exhaust gas temperature and sends that signal to the ECU, helping protect the engine from overheating and lean-running conditions. It suits riders doing routine maintenance or chasing a faulty temperature reading on a high-mileage sled.
Built For Performance
- Threaded probe body designed to seat securely in the exhaust stream
- Temperature-sensing element calibrated for two-stroke exhaust heat ranges
- Electrical connector shaped to match the factory harness plug
- Sealed construction against snow, moisture, and vibration
- Direct replacement for the original sensor without adapter hardware
Fits These Machines
- for Polaris RMK 700 2008
- for Polaris RMK 700 2009
- for Polaris RMK 700 2010
On-The-Job Use
- Restoring a failed exhaust temperature reading on trail and mountain sleds
- Routine replacement during top-end or exhaust service
- Diagnosing lean-running or overheating symptoms before they cause damage
- Seasonal maintenance before deep snow riding
Specs At A Glance
| Component Type | Exhaust temperature sensor |
| Position | Exhaust system |
| Connection | Plug-in to factory harness |
Good To Know
Q: Will this sensor plug straight into my sled's harness? A: Yes, the connector is shaped to match the factory plug on the listed RMK 700 model years. Confirm your original sensor connector style before ordering.
Q: How do I know my exhaust temp sensor has failed? A: Common signs include a check engine light, poor running, or temperature codes stored in the ECU. A scan tool reading confirms the fault before replacement.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
