Skip to product information
1 of 1

Exhaust Temperature Sensor for Ski-Doo Skandic WT 600 HO E-Tec 2011-2012

Exhaust Temperature Sensor for Ski-Doo Skandic WT 600 HO E-Tec 2011-2012

Regular price $197.99
Regular price Sale price $197.99
Sale Sold out
Quantity

Exhaust Temp Sensor for Ski-Doo Skandic WT 600 HO E-Tec

This exhaust temperature sensor monitors exhaust gas heat on the Ski-Doo Skandic WT 600 HO E-Tec and feeds that reading to the engine management system so fueling and overheat protection stay correct.

Overview

This exhaust temp sensor is a replacement unit for the Ski-Doo Skandic WT 600 HO E-Tec produced between 2011 and 2012. It measures exhaust gas temperature and delivers the signal the ECU relies on for fueling and engine protection. A practical choice for utility riders maintaining a hard-working sled.

Built For Performance

  • Threaded probe shaped to seat in the factory exhaust sensor location
  • Thermocouple construction rated for continuous high exhaust gas temperatures
  • Sealed connector and insulated lead that resist snow, water, and vibration
  • Output curve matched to the E-Tec engine management system
  • Low-profile body that clears nearby exhaust and chassis parts

Fits These Machines

  • for Ski-Doo Skandic WT 600 HO E-Tec, 2011
  • for Ski-Doo Skandic WT 600 HO E-Tec, 2012

On-The-Job Use

  • Utility work where the sled pulls loads and heat load on the exhaust runs high
  • Trail and backcountry riding where exhaust temperature swings with throttle
  • Service after an exhaust temperature fault code appears
  • Diagnostics when chasing poor running or erratic fueling

Specs At A Glance

Part Type Exhaust Temperature Sensor
Model Skandic WT 600 HO E-Tec
Years 2011-2012

Good To Know

Q: How can I tell the exhaust temp sensor has failed? A: Warning lights, exhaust temperature fault codes, and running problems that show up once the engine is hot are typical signs. Comparing sensor output to the service spec confirms it.

Q: Is any calibration needed after fitting this sensor? A: No programming is required, since it connects directly to the factory harness like the original. Clear any stored codes after installation and verify live readings.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details