Skip to product information
1 of 1

Exhaust Temperature Sensor for Ski-Doo Summit Everest 800R E-Tec 2011

Exhaust Temperature Sensor for Ski-Doo Summit Everest 800R E-Tec 2011

Regular price $197.99
Regular price Sale price $197.99
Sale Sold out
Quantity

Exhaust Temp/Temperature Sensor for Ski-Doo

This exhaust temperature sensor monitors exhaust gas heat on Ski-Doo Summit Everest 800R E-Tec snowmobiles so the engine management system can fine-tune fuel delivery and protect the powerplant.

Overview

This exhaust temp sensor for Ski-Doo reads exhaust gas temperature on Summit Everest 800R E-Tec models and relays that data to the engine control unit. The ECU uses the reading to adjust fuel mixture and timing, protecting the engine from lean running or overheating. It suits riders who need a dependable replacement exhaust temperature sensor for their 800R E-Tec snowmobile.

Built For Performance

  • Direct-fit exhaust temperature sensor for the 800R E-Tec engine platform
  • Threaded probe mounts into the exhaust stream to sample gas temperature
  • Signal output feeds the ECU for real-time fuel and timing correction
  • Constructed to withstand the heat cycling of two-stroke exhaust systems
  • Plug-in connector matches the factory wiring harness on listed models

Fits These Machines

  • for Ski-Doo Summit Everest 800R E-Tec 2011

On-The-Job Use

  • Restoring proper exhaust temperature feedback after a sensor failure
  • Trail and mountain riding where consistent fueling matters
  • Routine replacement during engine or exhaust service
  • Diagnosing lean-run and overheating conditions tied to sensor faults

Specs At A Glance

Part Type Exhaust Temperature Sensor
Application 800R E-Tec engine
Model Year 2011

Good To Know

Q: How do I know if my exhaust temp sensor has failed? A: Common signs include poor running, check engine codes, or rich and lean running conditions on your 800R E-Tec. A diagnostic scan gives the clearest confirmation before replacement.

Q: Can this sensor be installed without special tools? A: It threads into the exhaust and connects to the factory harness, so basic hand tools and a wrench for the sensor body are usually enough. Take care not to overtighten the probe.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details