Skip to product information
1 of 1

Exhaust Temperature Temp Sensor for Yamaha SR Viper All Versions 2014-2016

Exhaust Temperature Temp Sensor for Yamaha SR Viper All Versions 2014-2016

Regular price $164.99
Regular price Sale price $164.99
Sale Sold out
Quantity

Exhaust Temperature Sensor for Yamaha SR Viper

This exhaust temp sensor for Yamaha SR Viper machines reads exhaust gas temperature and relays that signal to the ECU, serving as a direct replacement for the factory sensor across all 2014 through 2016 versions.

Overview

This exhaust temperature sensor is built to monitor exhaust gas heat on Yamaha SR Viper snowmobiles from 2014 to 2016. The sensor sends a live temperature signal to the engine control unit so fueling and protection strategies stay accurate. It suits riders replacing a failed or heat-damaged sensor on any SR Viper version.

Built For Performance

  • Threaded probe designed to seat into the exhaust stream for direct temperature reading
  • Sealed connector body resists moisture, snow, and road spray
  • Heat-rated housing handles sustained high exhaust temperatures
  • Direct-fit replacement for the factory exhaust temp sensor location
  • Plug-in electrical connection for straightforward installation

Fits These Machines

  • for Yamaha SR Viper (all versions) 2014
  • for Yamaha SR Viper (all versions) 2015
  • for Yamaha SR Viper (all versions) 2016

On-The-Job Use

  • Trail riding where consistent exhaust temperature readings keep the ECU in tune
  • Deep snow and mountain riding with sustained engine load
  • Routine replacement when a sensor fails or reads erratically
  • Seasonal maintenance before the snow season begins

Specs At A Glance

Sensor Type Exhaust gas temperature
Vehicle Fit for Yamaha SR Viper, 2014-2016, all versions
Connection Plug-in electrical connector

Good To Know

Q: How do I know the exhaust temp sensor has failed? A: A failed sensor commonly triggers a fault code, poor running, or a temperature reading that sits flat or swings wildly. Scan the ECU for stored codes before replacing to confirm.

Q: Do I need to reset the ECU after installing this sensor? A: On most machines the new sensor is recognized once the ignition cycles and codes are cleared. Check for stored fault codes after installation to confirm the reading is correct.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.

Get it between -

View full details